Homely Commissioning
✅ Complete guidance in the Homely Installer App.
✅ Connect the Hub to WiFi.
✅ Connect the Hub to the Node and place the Node within the recommended guidelines.
✅ Run a system check to confirm all functions are connected and signals are within tolerance.
✅ Configure settings:
-
Select hot water tank size, heat emitter types, and immersion configuration.
-
Commission the heat pump.
✅ Verify Hub data:
-
Open the menu for the newly installed Hub.
-
Confirm last reading is up to date.
-
Ensure WiFi signal is OK or better.
✅ Check Node data:
-
Confirm last reading is up to date.
-
Battery level must be medium or above (replace if needed).
-
Signal strength must be good or better.
✅ Check Modbus data:
-
Ensure Modbus time is up to date.
-
Confirm values/temperatures are being read (not showing 0°C).
✅ Test heat pump:
-
Open the Heat pump controls section of the app.
-
Turn on the heating toggle and verify operation.
-
Turn on the hot water toggle and verify operation.
-